Return Defaults¶

!!

We now hold ‘Return’ defaults by the customer.
A new tab has been required in the Customer form called ‘Return Defaults’.
It holds ‘Measure To’ and ‘Return’.
If there is a record in here, it will be used when a detail line with a ‘Return’ is entered or imported via EDI.

Previously if ‘Enter Valance Size’ is switched on, when an option is changed, the ‘Valance Width’ and ‘Return Length’ were always recalculated.
There is a new parameter called ‘Non Calculated Valance’so this will not happen.
It is held in the blind type record and is only shown if ‘Enter Valance Size’ is switched on.
If this is set to true, then the ‘Valance Width’ and ‘Return Length’ can be entered manually and will not be changed.
Also, they will not look at ‘Return Valance Size Add On’ or the ‘Return Defaults’ for customers.